American Standard Plumbing Product 8473000H User Manual

8473000H  
8474000H  
Installation Instructions/Warranty Information  
7. With washer positioned in showerhead, attach  
showerhead to slide bar by rotating the whole  
showerhead clockwise while firmly holding slide  
bar in place. Hand tighten only. Once tightened,  
rotate showerhead so that the spray settings tab  
is positioned along the bottom of the showerhead.  
1. Remove old showerhead  
with wrench. Clean threads  
of shower arm  
8. Your shower hose is equipped with a permanently installed  
vacuum breaker which is located on the end with the yellow tape.  
Remove the yellow tape and bag from hose and insert washer into  
hose nut. Connect this end of the hose to the diverter valve located  
on the bottom of the slide bar. Hand tighten only. If you install the  
wrong end of the hose to the diverter valve, water will not flow to  
the hand held shower. Note: The end of the hose that contains the  
vacuum breaker will discharge water every time you turn your  
shower on or off. This is normal. The water is simply draining out,  
and will stop when the water is drained. Do not mistake this for a  
leak! Some plumbing codes require a vacuum breaker to protect  
your local water supply from the back- flow of water.  
2. Apply thread tape (in  
a clockwise direction) to  
threads of shower arm.  
3. The slide bar can be mounted  
using the preassembled suction  
cup or by using the optional  
adhesive pad. The suction cup  
can only be used on smooth, flat  
surfaces. If your shower wall has  
a rough surface, or if there is a  
grout line present, then you will  
need to use the adhesive pad.  
Note: Some tub-surrounds will  
9. Remove the bag from the other end of the hose and insert  
washer into hose nut. Hand tighten this end of the hose to the  
hand held shower.  
appear to have a smooth, flat surface,  
but will actually have a light texture  
that is not noticeable at first. If this is  
the case, it will prevent the suction cup  
from maintaining a hold, and you will  
need to use the adhesive pad. To  
remove the suction cup from the slide  
bar, rotate suction cup counter clockwise  
(while suction cup is facing you), and then  
thread on the adhesive pad.  
10. Fit hand held shower into mounting bracket by slipping the hose  
through the bracket opening and seating the hand held shower  
into the bracket.  
4. Determine if you want the hand held  
shower to be positioned on the right side  
or left side of the slide bar. To reposition  
the hand held bracket, place fingers  
on button while having your thumb  
positioned underneath the bracket.  
Firmly press the button and rotate the  
bracket to the other side of the slide bar.  
To adjust the height of the hand held shower: locate the button on  
the top of the bracket, then position two fingers on top of the button,  
and your thumb on the underside of the bracket. Firmly squeeze the  
button and slide the bracket up or down to desired height.  
Adjusting the angle of the hand held shower: For a higher angle,  
grasp the handle of the handheld shower and push it back to rotate the  
bracket away from you. To adjust the angle lower, pull hand held shower  
towards you. Turn on water and check for leaks.  
5. With screen washer positioned in  
mounting nut located on the top of  
the slide bar, attach slide bar to  
shower arm by rotating mounting  
nut clockwise. Hand tighten, then  
lightly snug with a wrench. DO NOT  
OVER TIGHTEN.  
11. The diverter valve located at the bottom of the slide bar directs  
the water to the showerhead, hand held, or both at the same time.  
To direct water to the showerhead, position lever all the  
way to the left.  
To direct water to the hand held shower, position lever all  
the way to the right.  
To direct water to both the showerhead and hand held shower,  
position lever in the center.  
LIMITED LIFETIME FUNCTION AND FINISH WARRANTY  
6. To secure slide bar to wall using  
adhesive pad: Make sure wall is clean  
and dry. Remove adhesive backing,  
and with slide bar centered with  
shower arm, firmly press adhesive  
pad to wall.  
American Standard warrants this product to be free from defects in materials or workmanship for as  
long as the original consumer purchaser owns this product. American Standard will provide free of  
charge, at it's sole option, replacement part(s) or product (or if no longer available, a comparable  
product) to replace those which have proven defective in materials or workmanship. Proof of purchase  
(original sales receipt) from the original consumer purchaser must be made available to American  
Standard for all warranty claims. This warranty is non transferable. It does not apply in the event of  
product damage due to the use of other than genuine American Standard replacement parts, installation  
error, abuse, misuse or improper care and maintenance (whether performed by a plumber, contractor,  
service provider or member of the purchaser's household). The warranty excludes damage due to  
aggressive air or water conditions, or harsh or abrasive cleaners and/or materials. This warranty  
excludes all industrial, commercial and business usage, whose purchasers are hereby extended a two  
year limited warranty (with the exception of solenoid valves and other electronic components which  
carry a one year warranty) applying to all other terms of this warranty except duration. This warranty  
does not cover labor charges incurred and/or damage sustained in installation, repair or replacement,  
nor incidental or consequential damages. This warranty is applicable only to American Standard  
showers manufactured after June 1, 1996 and installed in the United States, Mexico and/or Canada. THIS  
WARRANTY IS EXCLUSIVELY IN LIEU OF ALL OTHER WARRANTIES, INCLUDING ANY IMPLIED  
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This warranty gives  
the original consumer purchaser of an American Standard shower specific legal rights which may vary  
from state to state or from province to province. In some states or provinces the exclusion or limitation  
of incidental or consequential damages is not allowed, so those exclusions may not apply to you.  
To secure slide bar to wall using  
suction cup: Make sure wall is clean.  
Lightly moisten suction cup, and with  
slide bar centered with shower arm,  
firmly press suction cup to wall.  
If you need installation assistance, replacement parts, or  
have questions regarding our warranty, please call  
our product consultants at: 1-877-283-2664, 8 a.m.-5 p.m., EST,  
Monday-Friday, or email us at [email protected]  
©2010 American Standard, Inc.  
American Standard Companies  
1 Centennial Avenue  
Piscataway, NJ 08855  
Made in China  
 

Acnodes Computer Monitor APH 8190 User Manual
ADC Stereo System MMW 100 User Manual
ADTRAN Network Router DSU 56 User Manual
AEG Cooktop HK854220IB User Manual
AGFA Digital Camera DC 8338i User Manual
American Standard Hot Tub 7242XXXW User Manual
Audiovox Car Stereo System ACD 27 User Manual
Axis Communications Security Camera Q1932E User Manual
Behringer DJ Equipment PRO MIXER DJX750 User Manual
Beko Iron BKK2174 User Manual